The terminology "dual-channel DDR" is, in fact, a misnomer. The fact is there's
no such thing as dual-channel DDR memory. What there are, however, are
When properly used, the term "dual channel" refers to a DDR motherboards
chipset that's designed with two memory channels instead of one. The two
channels handle memory-processing more efficiently by utilizing the theoretical
bandwidth of the two modules, thus reducing system latencies, the timing delays
that inherently occur with one memory module. For example, one controller reads
and writes data while the second controller prepares for the next access, hence,
eliminating the reset and setup delays that occur before one memory module can
begin the read/write process all over again.
Consider an analogy in which data is filled into a funnel (memory), which then
"channels" the data to the CPU.
Single-channel memory would feed the data to the processor via a single
funnel at a maximum rate of 64 bits at a time. Dual-channel memory, on the other
hand, utilizes two funnels, thereby having the capability to deliver data twice
as fast, at up to 128 bits at a time. The process works the same way when data
is "emptied" from the processor by reversing the flow of data. A "memory
controller" chip is responsible for handling all data transfers involving the
memory modules and the processor. This controls the flow of data through the
funnels, preventing them from being over-filled with data.
It is estimated that a dual-channel memory architecture is capable of
increasing bandwidth by as much as 10%.
The majority of systems supporting dual-channel memory can be configured in
either single-channel or dual-channel memory mode. The fact that a motherboard
supports dual-channel DDR memory, does not guarantee that installed DIMMs will
be utilized in dual-channel mode. It is not sufficient to just plug multiple
memory modules into their sockets to get dual-channel memory operation – users
need to follow specific rules when adding memory modules to ensure that they get
dual-channel memory performance. Intel specifies that motherboards should
default to single-channel mode in the event of any of these being violated:
- DIMMs must be installed in pairs
- Both DIMMs must use the same density memory chips
- Both DIMMs must use the same DRAM bus width
- Both DIMMs must be either single-sided or dual-sided.